Filter Configuration Command Reference
526 Router Configuration Guide
Description This command enables the context to configure log summarization. These settings will only be taken
into account when syslog is the log destination.
summary-crit
Syntax summary-crit dst-addr
summary-crit src-addr
no summary-crit
Context config>filter>log>summary
Description This command defines the key of the index of the minitable. If key information is changed while
summary is administratively enabled (no shutdown), the filter summary minitable is flushed and
recreated with different key information. Log packets received during the reconfiguration time will be
handled as if summary was not active.
The no form of the command reverts to the default parameter.
Default src-addr
Parameters dst-addr — Specifies that received log packets are summarized based on the destination IPv4,
IPv6, or MAC address.
src-addr — Specifies that received log packets are summarized based on the source IPv4, IPv6
or MAC address.
wrap-around
Syntax [no] wrap-around
Context config>filter>log
Description This command configures a memory filter log to log until full or to store the most recent log entries
(circular buffer).
Specifying wrap-around configures the memory filter log to store the most recent filter log entries
(circular buffer). When the log is full, the oldest filter log entries are overwritten with new entries.
The no form of the command configures the memory filter log to accept filter log entries until full.
When the memory filter log is full, filter logging for the log filter ID ceases.
Default wrap-around
To Next Page
Loading...
