Filter Configuration Command Reference
532 Router Configuration Guide
The no form of the command sets the scope of the policy to the default of template.
Default template
Parameters exclusive — When the scope of a policy is defined as exclusive, the policy can only be applied to
a single entity. Attempting to assign the policy to a second entity will result in an error
message.
template — When the scope of a policy is defined as template, the policy can be applied to
multiple entities.
embedded — When the scope of a policy is defined as embedded, the policy cannot be applied
directly. The policy defines embedded filter rules, which are embedded by other exclusive/
template/system filter policies. The embedded scope is supported for IPv4 and IPv6 filter
policies only.
system — When the scope of a policy is defined as system, the policy defines system-wide filter
rules. To apply system policy rules, activate system filter and chain exclusive/template ACL
filter policy to the system filter. The system scope is supported for IPv4 and IPv6 filter
policies only.
shared-radius-filter-wmark
Syntax shared-radius-filter-wmark low low-watermark high high-watermark
no shared-radius-filter-wmark
Context config>filter>ip-filter
config>filter>ipv6-filter
Description This command configures the low and high watermark for the number of RADIUS shared filters
reporting
Default no shared-radius-filter-wmark
Parameters low low-watermark — Specifies the utilization of the filter ranges for filter entry insertion, at
which a table full alarm will be raised by the agent.
Values 0 to 8000
high high-watermark — Specifies the utilization of the filter ranges for filter entry insertion, at
which a table full alarm will be cleared by the agent.
Values 1 to 8000
sub-insert-credit-control
Syntax sub-insert-credit-control start-entry entry-id count count
no sub-insert-credit-control
Context config>filter>ip-filter
config>filter>ipv6-filter
To Next Page
Loading...
