Filter Configuration Command Reference
534 Router Configuration Guide
Parameters start-entry entry-id — Specifies the lowest entry in the range.
Values 1 to 65535
count count — Specifies the number of entries in the range.
Values 1 to 65535
sub-insert-shared-radius
Syntax sub-insert-shared-radius start-entry entry-id count count
no sub-insert-shared-radius
Context config>filter>ip-filter
config>filter>ipv6-filter
Description This command configures the insert point for shared host rules from RADIUS.
Default no sub-insert-shared-radius
Parameters entry entry-id — Identifies a filter on this system.
Values 1 to 65535
count count — Specifies the count.
Values 1 to 65535
sub-insert-wmark
Syntax sub-insert-wmark low low-watermark high high-watermark
no sub-insert-wmark
Context config>filter>ip-filter
config>filter>ipv6-filter
Description This command configures the low and high watermark percentage for inserted filter entry usage
reporting.
The no form of the command reverts to the default.
Default sub-insert-wmark low 90 high 95
Parameters low low-watermark — Specifies the utilization of the filter ranges for filter entry insertion, at
which a table full alarm will be cleared by the agent.
Values 0 to 100
high high-watermark — Specifies the utilization of the filter ranges for filter entry insertion, at
which a table full alarm will be raised by the agent.
Values 0 to 100
To Next Page
Loading...
