Filter Configuration Command Reference
544 Router Configuration Guide
range — Specifies an inclusive range. When range is used, the start of the range (first value
entered) must be smaller than the end of the range (second value entered).
egress-pbr
Syntax egress-pbr {default-load-balancing | l4-load-balancing}
no egress-pbr
Context config>filter>ip-filter>entry
config>filter>ipv6-filter>entry
Description This command specifies that the configured PBR action is applicable to egress processing. The
command should only be enabled in ACL policies used by residential subscribers. Enabling
egress-pbr on filters not deployed for residential subscribers is not blocked but may lead to
unexpected behavior and thus should be avoided.
The no form of this command removes the egress-pbr designation of the filter entry's action.
Default no egress-pbr
Parameters default-load-balancing — set load-balancing to the default (hash based on SA/DA of the packet)
l4-load-balancing — include TCP/UDP port (if available) in the hash
filter-sample
Syntax [no] filter-sample
Context config>filter>ip-filter>entry
config>filter>ipv6-filter>entry
Description This command enabled cflowd sampling for packets matching this filter entry.
If the cflowd is either not enabled or set to cflowd interface mode, this command is ignored.
The no form disables the cflowd sampling using this filter entry.
Default no filter-sample
interface-disable-sample
Syntax [no] interface-disable-sample
Context config>filter>ip-filter>entry
config>filter>ipv6-filter>entry
To Next Page
Loading...
