Filter Policies
Router Configuration Guide 545
Description This command disables cflowd sampling for packets matching this filter entry for the IP interface is
set to cflowd interface mode. This allows the option to not sample specific types of traffic when
interface sampling is enabled.
If the cflowd is either not enabled or set to cflowd acl mode, this command is ignored.
The no form of this command enables sampling.
Default no interface-disable-sample
match
Syntax match [protocol protocol-id]
no match
Context config>filter>ip-filter>entry
Description This command enables the context to enter match criteria for the filter entry. When the match criteria
have been satisfied the action associated with the match criteria is executed.
A match context may consist of multiple match criteria, but multiple match statements cannot be
entered per entry.
The no form of the command removes the match criteria from the filter entry.
Parameters protocol — The protocol keyword configures an IP protocol to be used as an IP filter match
criterion. The protocol type such as TCP or UDP is identified by its respective protocol
number.
protocol-id — Configures the decimal value representing the IP protocol to be used as an IP filter
match criterion. Well known protocol numbers include ICMP(1), TCP(6), UDP(17). The no
form the command removes the protocol from the match criteria.
Default Value: none (keyword)
Values 0 to 255 in decimal format. Values can also be specified in
hexadecimal format, in binary format, or using the keywords the
following keywords:
keywords: none, icmp, igmp, ip, tcp, egp, igp, udp, rdp, ipv6,
ipv6-route, ipv6-frag, idrp, rsvp, gre, ipv6-icmp, ipv6-no-nxt,
ipv6-opts, iso-ip, eigrp, ospf-igp, ether-ip, encap, pnni, pim, vrrp,
l2tp, stp, ptp, isis, crtp, crudp, sctp
* — udp/tcp wildcard
Table 44: Protocol ID Descriptions
Protocol Protocol ID Description
icmp 1 Internet Control Message
To Next Page
Loading...
