Filter Configuration Command Reference
578 Router Configuration Guide
Default none
Parameters return-value — Specifies the SNMP value against which the test result is matched.
Values A maximum of 256 characters.
type return-type — Specifies the SNMP object type against which the test result is matched.
Values integer, unsigned, string, ip-address, counter, time-ticks, opaque
disable — The keyword that specifies that the destination may not be used for the amount of time
specified in the hold-time command when the test result matches the criterion.
lower-priority priority — Specifies the amount to lower the priority of the destination.
Values 1 to 255
raise-priority priority — Specifies the amount to raise the priority of the destination.
Values 1 to 255
unicast-rt-test
Syntax unicast-rt-test
no unicast-rt-test
Context config>filter>redirect-policy>dest
Description This command configures a unicast route test for this destination. A destination is eligible for redirect
if a valid unicast route to that destination exists in the routing instance specified by
config>filter>redirect-policy>router. The unicast route test is mutually exclusive with other
redirect-policy test types.
The test cannot be configured if no router is configured for this redirect policy.
The no form of the command disables the test.
Default no unicast-rt-test
url-test
Syntax url-test test-name
no url-test test-name
Context config>filter>redirect-policy>dest
Description The context to enable URL test parameters. IP filters can be used to selectively cache some web sites.
Default none
To Next Page
Loading...
