Alcatel-Lucent 7450 - Page 579

Filter Policies
Router Configuration Guide 579
Parameters test-name — The name of the URL test. Allowed values are any string up to 32 characters long
composed of printable, 7-bit ASCII characters. If the string contains special characters (#, $,
spaces, etc.), the entire string must be enclosed within double quotes.
return-code
Syntax return-code return-code-1 [return-code-2] [disable | lower-priority priority | raise-priority
priority]
no return-code return-code-1 [return-code-2]
Context config>filter>redirect-policy>dest>url-test
Description Return codes are returned when the URL test is performed. Values for the specified range are the return
codes which can be given back to the system as a result of the test been performed.
For example, error code 401 for HTTP is “page not found.” If, while performing this test, the URL is
not reachable, you can lower the priority by 10 points so that other means of reaching this destination
are prioritized higher than the older one.
Default none
Parameters return-code-1, return-code-2 — Specifies a range of return codes. When the URL test return-code
falls within the specified range, the corresponding action is performed.
Values return-code-1: 1 to 4294967294
return-code-2: 2 to 4294967295
disable — Specifies that the destination may not be used for the amount of time specified in the
hold-time command when the return code falls within the specified range.
lower-priority priority — Specifies the amount to lower the priority of the destination when the
return code falls within the specified range.
raise-priority priority — Specifies the amount to raise the priority of the destination when the
return code falls within the specified range.
url
Syntax url url-string [http-version version-string]
no url
Context config>filter>redirect-policy>dest>url-test
Description This command specifies the URL to be probed by the URL test.
Default none
Parameters url-string — Specify a URL up to 255 characters in length.
http-version version-string — Specifies the HTTP version, 80 characters in length.