Show, Clear, Monitor, and Debug Command Reference
618 Router Configuration Guide
Parameters ipv6-filter-id — Specifies the IPv6 filter policy for which to display information. Values can be
expressed in different formats. The following only shows decimal integer format.
Values 1 to 65535
entry entry-id — Specifies the filter policy entry (of the specified filter policy) for which only to
display information..
Values 1 to 65535
filter-type filter-type — Specifies the type of filter to display.
Values config, flowspec, host-common, tms, openflow, vsd.
associations — Appends, to the detailed filter policy output, information as to where the specified
filter policy ID is applied.
counters — Displays counter information. Egress counters count the packets without Layer 2
encapsulation. Ingress counters count the packets with Layer 2 encapsulation.
embedded [inactive] — Shows all embeddings, optionally shows inactive embedding only, if
ipv6-filter-id is not specified shows all embedded filters.
type entry-type — Specifies type of filter entry to display:
Values fixed, radius-insert, credit-control-insert, embedded, radius-
shared
Output Show Filter (no filter-id specified) — The following table describes the command output for the
command when no filter ID is specified.
Table 54: Filter IPv6 Output Field Descriptions
Label Description
Filter Id The IP filter ID
Scope Template
The filter policy is of type template.
Exclusive
The filter policy is of type exclusive.
Applied No
The filter policy ID has not been applied.
Yes
The filter policy ID is applied.
Description The IP filter policy description.
In Shows embedding filter index
From Shows embedded filters included
Priority Shows priority of embedded filter
To Next Page
Loading...
