Show, Clear, Monitor, and Debug Command Reference
640 Router Configuration Guide
Admin Priority : 90 Oper Priority: 90
Admin State : Up Oper State : Down
URL Test : URL_to_Proxy
Interval : 10 Timeout : 10
Drop Count : 3
Hold Down : 0 Hold Remain : 0
Last Action at : 03/19/2007 05:04:15 Action Taken : Disable
Priority Change: 0 Return Code : 0
===============================================================================
A:ALA-A>config>filter#
A:ALA-A>show filter redirect-policy redirect1 dest 10.10.10.106
===============================================================================
Redirect Policy
===============================================================================
Redirect Policy: redirect1 Applied : Yes
Description : New redirect info
Active Dest : 10.10.10.104
-------------------------------------------------------------------------------
Destination : 10.10.10.106
-------------------------------------------------------------------------------
Description : (Not Specified)
Admin Priority : 90 Oper Priority: 90
Admin State : Up Oper State : Down
URL Test : URL_to_Proxy
Interval : 10 Timeout : 10
Drop Count : 3
Hold Down : 0 Hold Remain : 0
Last Action at : 03/19/2007 05:04:15 Action Taken : Disable
Priority Change: 0 Return Code : 0
===============================================================================
ALA-A#
system-filter
Syntax system-filter [chained-to]
Context show>filter
Description This command shows system filter information.
Parameters chained-to — This option displays filters that chain to a given system filter.
Output No Parameters Specified — When no parameters are specified, the following information is
displayed (grouped for IPv4 and IPv6): active system filter and all filters with scope system.
Sample Output
*A:Dut-C>show>filter# system-filter
===============================================================================
IP system filters
To Next Page
Loading...
