Alcatel-Lucent 7450 - Page 641

Filter Policies
Router Configuration Guide 641
===============================================================================
Filter-Id Active
-------------------------------------------------------------------------------
100 Yes
65535 No
-------------------------------------------------------------------------------
No. of IP system filters (total / active): 2 / 1
===============================================================================
===============================================================================
IPv6 system filters
===============================================================================
Filter-Id Active
-------------------------------------------------------------------------------
No Matching Entries
-------------------------------------------------------------------------------
No. of IPv6 system filters (total / active): 0 / 0
===============================================================================
With Option (chained-to) Specified — When the chained-to option is specified, the following
information is displayed.
*A:Dut-C>show>filter# system-filter chained-to
============================================================================
IP filters that chain to the active IP system filter
============================================================================
3 4 5 6
5:23 6:24
----------------------------------------------------------------------------
No. of IP filters that chain to the active IP system filter: 6
============================================================================
============================================================================
IPv6 filters that chain to the active IPv6 system filter
============================================================================
No Matching Entries
----------------------------------------------------------------------------
No. of IPv6 filters that chain to the active IPv6 system filter: 0
============================================================================
match-list
Syntax match-list
Context show>filter
Description This command enables the context to display information for match lists used in filter policies (IOM/
FP and CPM).