Filter Policies
Router Configuration Guide 651
Ipv6 fSpec-2345 0 0 0
No more Ipv6 filters
===============================================================================
ip
Syntax ip <filter-id>
Context tools>dump>filter>resources
Description This command displays information about the specified IP filter including resource utilization on CPM
and IOM, the IOMs on which the filter is used, and the entries using the most resources.
Parameters filter-id — specifies that only the filter resource utilization associated with this IP filter will be
displayed.
Values 1 to 65535
Output
Sample Output
*A:Dut-C>tools>dump>filter>resources># ip 100
===============================================================================
Resource utilization details for Ip filter 100
===============================================================================
CPM entries used : 5
CPM subentries used : 5
TCAM entries used (per FlexPath) : 5
Associated with IOMs : 1,2,3,4,5,6,7,8,9,10
---------------------------------------------------------------------------
Largest 5 entries
---------------------------------------------------------------------------
Entry ID Active TCAM entries
(per FlexPath)
---------------------------------------------------------------------------
3 Yes 1
4 Yes 1
5 Yes 1
6 Yes 1
100 Yes 1
---------------------------------------------------------------------------
===============================================================================
ipv6
Syntax ipv6 <filter-id>
To Next Page
Loading...
