Show, Clear, Monitor, and Debug Command Reference
652 Router Configuration Guide
Context tools>dump>filter>resources
Description This command displays information about the specified IPv6 filter including resource utilization on
CPM and IOM, the IOMs on which the filter is used, and the entries using the most resources.
Parameters filter-id — specifies that only the filter resource utilization associated with this IPv6 filter will be
displayed.
Values 1 to 65535
Output
Sample Output
*A:Dut-C>tools>dump>filter>resources># ipv6 "fSpec-0"
===============================================================================
Resource utilization details for Ipv6 filter fSpec-0
===============================================================================
CPM entries used : 0
CPM subentries used : 0
TCAM entries used (per FlexPath) : 0
Associated with IOMs : 2
---------------------------------------------------------------------------
Largest 5 entries
---------------------------------------------------------------------------
Entry ID Active TCAM entries
(per FlexPath)
---------------------------------------------------------------------------
No Matching Entries
---------------------------------------------------------------------------
===============================================================================
mac
Syntax mac <filter-id>
Context tools>dump>filter>resources
Description This command displays information about the specified MAC filter including resource utilization on
CPM and IOM, the IOMs on which the filter is used, and the entries using the most resources.
Parameters filter-id — specifies that only the filter resource utilization associated with this IPv6 filter will be
displayed.
Values 1 to 65535
Output
Sample Output
To Next Page
Loading...
