Cflowd Configuration Command Reference
736 Router Configuration Guide
port — Specifies the UDP port number on the remote Cflowd collector host to receive the
exported Cflowd data.
Values 1 to 65535
Default 2055
version — Specifies the version of the flow data collector.
Values Netflow v5, v8, v9, v10 (IPFIX) format
Default 5
aggregation
Syntax [no] aggregation
Context config>cflowd>collector
Description This command configures the type of aggregation scheme to be exported.
Specifies the type of data to be aggregated and to the collector.
To configure aggregation, you must decide which type of aggregation scheme to configure:
autonomous system, destination prefix, protocol port, raw, source destination, or source prefix.
This can only be configured if the collector version is configured as V8.
The no form of this command removes all aggregation types from the collector configuration.
Default no aggregation
as-matrix
Syntax [no] as-matrix
Context config>cflowd>collector>aggregation
Description This command specifies that the aggregation data should be based on autonomous system (AS)
information. An AS matrix contains packet and byte counters for traffic from either source-destination
autonomous systems or last-peer to next-peer autonomous systems.
The no form of this command removes this type of aggregation from the collector configuration.
Default no as-matrix
destination-prefix
Syntax [no] destination-prefix
To Next Page
Loading...
