Product information and planning
MPR-e 159
The time-out period starts at the activation time and automatically expires in the NE at the
end of the period, unless another reconfiguration of the time-out period is requested at the
operator interface during the activation time. If the loopback is still active because the
activation time-out is not expired yet, the time-out period is reconfigurable and the specified
time range starts again from the new updated activation date, overwriting the previous
activation date and time-out values.
After the NE reset, the activation of each loopback is disabled and must be recreated again if
needed, starting with a new time-out period.
Loopback life time
In order to avoid the risk of a permanent disconnection from MCT/NMS of a remote NE after
the execution of a loopback, a time-out mechanism is supported.
The management system's operator has to provide the time range of the loopback time-out
period expressed in hours/minutes starting from the time of the loopback activation.
A default time-out period may be suggested at the operator interface, even if it could be
modified on user-needs basis.
After the NE reset, the activation of each loopback point is lost and must be recreated again
if needed, starting with a new time-out period.
MPR-A: Unlicensed radio for 9558HC
The JF6-9558HC/6933B-9558HC (9558HC) unlicensed radio provide fast deployment of
service with microwave radio. No license and small antennas (no FCC and Industry Canada
(IC) requirements) allow immediate Turn-Up. The 9558HC unlicensed radio can not be
upgraded to licensed.
Note: Changes or modifications not expressly approved by Alcatel-Lucent could void the
authority to operate the JF6-9558HC/6933B-9558HC unlicensed radio.
Note: Installation, Turn-Up, Maintenance, and Operation Instruction supplied with the JF6-
9558HC/6933B-9558HC unlicensed radio require strict adherence for continued part 15 of
the FCC Rules and IC RSS-210 compliance.
To Next Page
Loading...
