NE management by software application
MPR-e 217
Figure 110: XPIC with horizontal polarization system overview
When the XPIC has been configured in the Radio Synthesis tab-panel the XPD value
is shown (see Figure 111).
Figure 111: XPD
Warning: When you change a radio parameter (such as modulation mode ACM/FCM,
modulation/capacity, Tx or Rx freq or shifter value), a warning message is raised (see
Figure 112). You need to ensure that the radio configuration between the two MPTs
involved in XPIC is aligned.
To Next Page
Loading...
