Applicability
26 MPR-e
SAFETY RECOMMENDATIONS
The safety recommendations below must be considered to avoid injuries to persons and/or
damage to the equipment:
•1)Service Personnel
Installation and service must be carried out by authorized persons having appropriate
technical training and experience necessary to be aware of hazardous operations
during installation and service, so as to prevent any personal injury or danger to other
persons, as well as to prevent damage to equipment.
•2)Access to the Equipment
Access to the equipment in use must be restricted to Service Personnel only.
•3)Safety Rules
Recommended safety rules are listed in Safety, EMC, EMF, ESD norms, equipment
labeling, standards and compliance.
Local safety regulations must be used if mandatory. Safety instructions in this
manual should be used in addition to the local safety regulations. In case of conflict
between safety instructions stated in this manual and those indicated in local
regulations, mandatory local norms will prevail. Should local regulations not be
mandatory, then safety rules stated in this manual will prevail.
SERVICE PERSONNEL SKILL
Service Personnel must have an adequate technical background in telecommunications and
in particular in the equipment that is the subject of this manual.
An adequate background is required to properly install, operate and maintain equipment.
Merely reading this manual is not considered sufficient.
Applicability
This manual applies to the following product release:
Table 1: Product and Release
PRODUCT RELEASE
9500 MPR-A and 9500 MPR-E
To Next Page
Loading...
