NE management by software application
MPR-e 231
Figure 125: Areas
1. Configure the Area Identifier and Area Type fields, then click on the Add
button. A configuration message will appear.
Figure 126: OSPF Areas Management
2. Click on the OK button.
Figure 127: Configuration message
The 9500 MPR OSPF parameters are:
→ Hello Interval: 10 seconds
→ Router Dead Interval: 40 seconds
→ Retransmit Interval: 5 seconds
→ Interface Transit Delay: 1 second
→ MTU: 1500 bytes
• How to remove an OSPF Area
Note: When the 9500 MPR is used with other equipment, the OSPF interface parameters
of the equipment must be the same as those of the related TMN interface on the 9500 MPR.
To Next Page
Loading...
