9500 family overview
66 MPR-e
Preparing the O-Ring Cable
Modify the pigtail O-ring cable by cutting off the output terminals (the O-ring lug connectors)
on the O-ring cable and splicing the open-ended wires to interface with the DC power
terminal block on the PIB.
To modify the pigtail O-ring cable:
• Cut off the O-ring lugs (items 1 and 2 on the cable in AC Power O-Ring Pigtail Cable
Assembly) and strip approximately 0.5 cm of shield from each wire to expose the
conductors. See Modified AC Power O-Ring Pigtail Cable.
Figure 17: Modified AC Power O-Ring Pigtail Cable
Connecting the AC Power Converter to the DC inputs on the PIB
To connect the AC power converter to the DC inputs on the PIB:
• Connect the modified end of the pigtail O-ring cable to the DC inputs on the PIB.
Connect the -VDC (black wire) to the -Batt terminal on the PIB terminal block;
connect the +VDC (red wire) to the +Batt terminal on the PIB terminal block.
• Connect the male 6-pin connector on the AC Power Converter (item 1 in AC Power
Converter) to the female 6-pin connector on the pigtail cable (item 3 in AC Power O-
Ring Pigtail Cable Assembly).
• Plug the AC power converter cord (item 2 in AC Power Converter) into an AC power
outlet.
Optical interface
One Optical Ethernet cable connects the MPT-HC V2/9558HC to the Ethernet generic
Device and one coaxial cable connects the MPT-HC V2/9558HC to MPT Power Unit, MPT
Extended Power Unit, or office power.
Danger: Ensure that the power supply is disconnected from the AC main power feed before
preparing and cutting the DC wires.
23094
0.5 cm
(0.2 in)
To Next Page
Loading...
