Preface
MPR-e 27
Scope
This document describes the hardware and software functionalities.
This document is intended for the technicians involved in Planning, in Operation and
Maintenance and in Commissioning.
The 9500 MPR product supports both the ANSI standard, for the North American market,
and the ETSI standard, for other markets.
The 9500 MPR-e system is made up of an MPT-MC/MPT-HC V2/MPT-XP/9558HC in
standalone mode. MPR-e supports both ANSI and ETSI standards and is the term used when
referring to information that is common to both standards. When referring to information that
applies only to ANSI, this document uses the term MPR-A. When referring to information
that applies only to ETSI, this document uses the term MPR-E.
References to MPT-HC in this document refer to the MPT-HC V2.
History
MPR-e 5.0.0
Table 1: Product and Release
PRODUCT RELEASE
Table 2: Change history
ISSUE DATE DESCRIPTIONS
01 August 2013 Initial Release
To Next Page
Loading...
