Safety, EMC, EMF, ESD norms, equipment labeling, standards and compliance
MPR-e 41
The position of earth connection terminals is specified in the Hardware Installation section.
Heat-radiating mechanical parts: labeling and safety instructions
The presence of heat-radiating mechanical parts is indicated by the following warning label
in compliance with IEC 417 Norm, Fig.5041:
Harmful optical signals: labeling and safety instructions
The equipment contains Class 1 laser components according to IEC 60825-1 (paragraph 5).
The laser source is placed in the left side of the optional SFP plug-in, which must be installed
in the Core-E unit.
According to IEC 60825-1, the explanatory label is not applied to the equipment due to lack
of space.
Danger: Carefully observe the specific procedures for installation, turn-up, and
commissioning and maintenance of equipment parts where heat-radiating mechanical parts
are present, described in the relevant installation, turn-up, and commissioning and
maintenance documents and the following general rule:
Personal injury can be caused by heat. Avoid touching powered terminals with any exposed
part of your body.
To Next Page
Loading...
