NE management by software application
MPR-e 245
Figure 150: MCT connected to main MPT with failed synchronization log
In case of synchronization failure, check the state of the coupling cable. If
everything is clear, repeat the synchronization operation.
Backup / restore
This menu allows to make a backup (save the NE configuration to the PC) and to make a
restore (download a configuration, from a previously done backup, to the NE). The backup
and restore is done through FTP.
Note: in a Single NE mode with 7705 SAR configuration, MPR-e backup/restore is done
through the 7705 SAR via an FTP session directly on the 7705 SAR compact flash. The
MPR-e configuration is always saved on the 7705 SAR and can be backed up and restored
as a regular 7705 SAR config.cfg file.
To Next Page
Loading...
