Navigator area
238 MPR-e
Synchronization in 1+1 HSB
In single NE with 7705 SAR and in 1+1 HSB configuration, an alignment of the
configuration between Main MPT and Spare MPT is offered.
This synchronization is available from Main MPT to Spare MPT and for the following
configuration parameters:
• Telecom Standard (ETSI or ANSI)
• Shifter Duplex
• Tx and Rx frequencies
• Modulation FCM/ACM
• FCM Modulation Scheme
• ACM Modulation List
• ACM Switching Delay
• ACM Threshold offset
• ACM driving Best/Worst MSE
• Tx Radio Link ID
• Rx Radio Link ID
• RTPC/ATPC
• RTPC Tx Power
• ATPC Min/Max Tx - RSL Threshold
• ATPC Driving Min/Max RSL
• MPR-A only: ATPC High Power Timeout enabled
• MPR-A only: ATPC High Power Mode command
• QoS - VLAN to queue mapping
• QoS - DiffServ to queue mapping
• QoS - 802.1p to queue mapping
• QoS - queue scheduling
• QoS - Ethertype to queue mapping
• QoS - Restore default
• QoS - Classification Configuration
• QoS - TMN Traffic parameters (4093)
• QoS - Queue Size
• PM - Counter Thresholds
• Configure Ethernet Compression
To Next Page
