Safety instructions
multi EA 4000 Version 01.16 19
IMPORTANT
In case of contact with thymol immediately carry out the following first aid measures:
after skin contact:
Immediately remove contaminated clothing, dab affected skin areas with polyeth-
ylene glycol 400 then rinse thoroughly with plenty of water.
after eye contact:
Rinse the eyes with open eye lid several minutes with running water (min. 10
minutes), then immediately consult a physician (even if there are no apparent symp-
toms).
after inhalation:
Bring the affected person into fresh air.
after swallowing:
Give plenty of water to drink (possibly several liters). Avoid vomiting (perforation
risk). Do not attempt neutralization.
Always immediately consult a physician after carrying out the first aid measures!
Gelatin, Thymol blue
Gelatin and thymol blue are not hazardous substances in the meaning of the EC directives.
Carry out the following first aid measures in case of contact with these substances:
after inhalation:
Bring the affected person into fresh air.
after skin contact:
Rinse with plenty of water, take off contaminated clothing.
after eye contact:
Rinse with plenty of water with open lids.
after swallowing:
Give plenty of water to drink. In case of sickness consult a physician.
Formation of acetic acid vapor
During the chlorine analysis acetic acid vapor may form. This accumulates during the gas
phase above the electrolyte surface (titration cell) or in the module housing.
Acetic acid vapor is not only corrosive but also hazardous to health.
Do not inhale these vapors! Always connect the adsorption tube with active carbon in the
chlorine module without delay!
To Next Page
Loading...
Need help?
General
