Transport and storage
multi EA 4000 Version 01.16 137
10.4 Connecting and using the sampler
CAUTION
During installation and prior to handling samples make sure that the sampler is parallel to the
basic device and level with the operating tube! If the sample boat is moved into the furnace
at an angle or not at the correct height
relative to the operating tube, the ceramic hook can
break and the operating tube can be damaged.
10.4.1 Installing and adjusting the autosampler FPG 48
Connect the sampler to the analyzer as follows:
1. Place the sampler to the right of the ana-
lyzer.
2. Plug cable on the low voltage side of the
table power supply into the connection at
the rear of the sampler. Connect the power
supply to the mains network.
3. Connect the data cable supplied to the
"sampler" interface at the rear of the sam-
pler. Connect the other end of the cable to
the "sampler" interface at the rear of the
module with the control unit (C/S module or
Cl module).
4. Connect the boat sensor to the "aux" con-
nection at the rear of the sampler.
5. Plug the grounding conductor into the con-
nection at the rear of the basic device.
6. Position the sampler parallel to the basic
device. The hook extension must be cen-
tered with the gas airlock.
Caution:
A gap of 2 mm must remain between the
FPG 48 and the gas airlock to allow for the
compensation of thermal expansion of the
combustion tube. The FPG 48 must not
press against the gas airlock at any time.
7. Using the adjustable feet correct the height
of the sampler, if necessary. The bottom
edge of the opening of the gas airlock must
be level with the upper edge of the storage
surface of the sampler.
To Next Page
Loading...
Need help?
General
