Safety instructions
multi EA 4000 Version 01.16 11
3 Safety instructions
For your own safety and to ensure error-free and safe operation of the analyzer multi
EA 4000, please read this chapter carefully before using the appliance.
Observe all safety notes listed in this user manual and all messages and displayed by the
multiWin control and analysis software on the monitor.
3.1 Standards and directives
The analyzer was manufactured according to the currently valid technology regulations and
the approved safety related regulations.
During the construction of the analyzer the relevant safety and health requirements of the
applicable laws, standards and regulations were applied. The safety of the analyzer is con-
firmed by the CE mark and the declaration of conformity.
Information regarding safety corresponds to the currently valid regulations of the European
Union. In other countries the applicable laws and country specific regulations have to be
complied with.
Besides the safety instructions in this user manual and the local safety regulations that apply
to the operation of the analyzer the general applicable regulations regarding accident pre-
vention, occupational health and safety and environmental protection have to be observed
and complied with.
References to potential dangers do not replace the work protection regulations which must
be observed.
3.2 Symbols and signal words used
The user manual uses the following symbols and signal words to indicate hazards or instruc-
tions. The safety instructions are always placed before an action.
WARNING
Indicates a potentially hazardous situation.
If it is not prevented death or most serious injuries (incapacita
tion) can result.
CAUTION
Indicates a potentially hazardous situation.
If it is not prevented light or minor injuries and material damage can result.
CAUTION! HOT SURFACE!
Touching the hot surface can cause burns.
LECTRIC SHOCK IF TOUCHED!
To Next Page
Loading...
Need help?
General
