Safety instructions
12 Edition 01/2016 multi EA 4000
Indicates application hints and other especially useful information without any resulting ha
z-
ardous or damaging situations.
TION
Indicates application hints and information to aid the proper disposa
l and handling of the
substances and materials used.
3.3 Safety markings on the analyzer
Safety symbols have been attached to the analyzer and accessories whose content must
always be observed.
Damaged or missing safety symbols can cause incorrect actions leading to personal injury or
material damage! The safety symbols must not be removed! Damaged safety symbols must
be replaced without delay!
The following safety symbols have been attached to the analyzer and accessories:
surface
Warning against dangerous
electrical voltage
Warning against hand injury
from crushing
Warning against substanc-
es hazardous to health
Warning against corrosive
substances
3.4 Technical condition
The analyzer corresponds in its design and construction to the current state of the art tech-
nology. Unauthorized modifications or changes, especially such that affect the safety of the
staff and the environment, are generally not allowed.
The following has to be observed:
Any manipulation of the safety equipment is prohibited! In case of an accident ma-
nipulations of the safety equipment will be interpreted as deliberate!
The operator must only operate the analyzer in a sound and operationally safe con-
dition. The technical condition must always comply with the legal requirements and
regulations.
Prior to every use the analyzer must be checked for damage and sound condition.
Any changes in the analyzer affecting its safety must be reported by the operating
personnel to the operator without delay.
The equipment components must only be connected to supply cables intended and
designed for this purpose.
To Next Page
Loading...
Need help?
General
