11-11
MS9710A Initialize
MS9710
initial
This driver initializes the device and generates “instr handle.”
It sets the response data header to OFF.
To use a measuring instrument, this VI must be executed first.
Terminate the VI after completion of initialization.
RS-232C interface conditions are as follows:
Parity = Even; Stop Bit = 1; Character length = Fixed at 8 bits
Set MS9710C interface conditions to the above conditions. (For the setting method, see 2.2.3, “Setting RS-232C
interface conditions.”)
Input parameters
< GPIB >
GPIB address (8) ........................ Input a GPIB address.
ID query (Yes:T) ........................ Request the ID of the measuring instrument to check the device against it.
reset (No:F)................................. Reset the measuring instrument.
< RS-232C >
Port No. (COM1:0)..................... Input an RS-232C port number.
Speed (bps) (9600:4) .................. Set a transmission speed (600/1200/2400/4800/9600 bps).
ID query (Yes:T) ........................ Request the ID of the measuring instrument to check the device against it.
reset (No:F)................................. Reset the measuring instrument.
MS9710A Reset
MS9710
reset
This driver resets the measuring instrument.
After completion of resetting, the VI is terminated.
Input parameter:
timeout (ms) (600000) ................ Set a reset timeout time.
MS9710A Auto Measurement Star
MS9710
Auto
Measure
This driver starts automatic measurement.
After completion of measurement, the VI is terminated.
Input parameter:
imeout (ms) (600000) ................. Set an automatic measurement timeout time.
11.4 Description of Measuring Instrument Driver Functions
To Next Page
Loading...
Need help?
General
