Section 7 Inspection Software
7-10
[5] Diode Power Sensor (Diode sensor data display field)
Displays the data on the currently set sensor when a measurement is performed using
the diode (low power) sensor. Editing is performed in item [11] “Data Input”.
[6] Frequency data display field
Displays the frequency information on the power sensor. Although the displayed data
can be modified, it is recommended that the initial data be used.
[7] Calibration factor data display field
Displays the information on the power sensor calibration factor. Clicking this item
causes the information on the relevant cell to be displayed in item [11] “Data Input”,
allowing the setting to be changed.
[8] “Quit” button Selection of this item forcibly terminates the measurement.
[9] “OK” button Selection of this item displays a message prompting the confirmation of whether the
data is to be saved if changes to information were made, and starts a measurement.
[10] Input Grid (Sensor type display field)
Displays the type of sensor currently enabled to be edited. To change the display; click
item [4] “Reference Cal Factor” display field, item [6] “Frequency data display field”,
or item [7] “Calibration factor data display field”.
[11] Data Input (Data input field)
Used to change the data in item [6] “Frequency data display field” or item [7] “Calibra-
tion factor data display field”. See paragraph 7.6.3 “Registering Power Sensor and
Setting Calibration Factor” for more information on data editing.
To Next Page
Loading...
