Anritsu MT8802A - Inspection Software Development Environment; Inspection Software Program Setup

7-3
7.4 Program Setup
7.3 Development Environment
7.3.1 OS
• MS-Windows 95 or 3.1
7.3.2 Languages
• Visual Basic for Windows Ver. 2.0
• GPIB library (NI-488.2M)
7.4 Program Setup
7.4.1 Setting Up Program
This program is contained in a single setup disk.
Follow the steps below to set up this program.
(1) Insert the “MT8802A Radio Communication Analyzer Inspection Ver 3.0 Setup
Disk 1” into the disk drive of the controller.
(2) Use a Windows software application to start “Setup.exe.”
(3) After the program is started, perform the setup according to the instruction mes-
sages.
7.4.2 Starting Program
Start this program by following the procedure described below.
(1) Select “MT8802A Test System” and “Inspection Ver 3.0” by clicking “Start” and
“Program.”
(2) At the program start, the currently set information is read from the initial setting
file and the “Initial Menu” screen shown in Fig. 7-1 is displayed.
If the program does not start normally, for example, because the initial file is
corrupted; perform the setup again by following the procedure described in para-
graph 7.4.1 “Setting Up Program.”