Section 7 Inspection Software
7-2
7.1 Outline
This Section is written about the automatic inspection software of “MT8802A”.
7.2 System Configuration
The following equipment is required to run this program.
• Equipment under test: MT8802A Radio Communication Analyzer
• Equipment to be used: MG3633A Synthesized Signal Generator × 2 units
HP8665B Synthesized Signal Generator or equivalent*1
ML4803A Power Meter
MN63A Programmable Attenuator
Low LPF Low Band Low Pass Filter jig
High LPF High Band Low Pass Filter jig
MF1603A Frequency Counter
MS616B Modulation Analyzer
HP8903B Audio Analyzer
MG3670B Digital Signal Generator or equivalent *1
MS2602A Spectrum Analyzer
MS8604A Radio Transmitter Tester (for TDMA)
MS86047 Radio Transmitter Tester (for CDMA)
MN74A Channel Selector
HP54502 Digital Oscilloscope
HP8902A Measuring Receiver
AMP/ATT Amplifier/Attenuator jig
*1: Compatibility must be ensured with respect to the specifications and the GPIB
commands.
• Controller: IBM PC/AT compatible
• GPIB interface: PCII/IIA or equivalent (manufactured by National Instrument (NI) Corp.)
To Next Page
Loading...
