Anritsu MT8802A - Inspection Software Operations

7-1
Section 7 Inspection Software
7.1 Outline ...................................................................... 7-2
7.2 System Configuration ............................................... 7-2
7.3 Development Environment ....................................... 7-3
7.3.1 OS ................................................................. 7-3
7.3.2 Languages ..................................................... 7-3
7.4 Program Setup.......................................................... 7-3
7.4.1 Setting Up Program ....................................... 7-3
7.4.2 Starting Program ........................................... 7-3
7.5 Outline of Displayed Screen ..................................... 7-4
7.5.1 Initial Menu Screen ........................................ 7-4
7.5.2 Output Device Select (Measured Results
Output Destination Selection) Screen ........... 7-6
7.5.3 Path Check (Data File Output Directory Selection)
Screen ........................................................... 7-7
7.5.4 Device Connection Check (Measurement System
Setup Diagram Display) Screen .................... 7-8
7.5.5 Sensor Data Input (Power Sensor and
Calibration Factor Input) Screen ................... 7-9
7.5.6 Power Sensor Data Input (Power Sensor
Registration and Selection) Screen ............... 7-11
7.5.7 Serial Number and Cal Factor Input (100 MHz
Calibration Factor Data Input) Screen ........... 7-13
7.5.8 Attenuator Calibration Data Input Screen ...... 7-14
7.5.9 Attenuator Data Input of Linearity Measure
(Attenuator Calibration Data Input) Screen for
CDMA Measurement ..................................... 7-16
7.5.10 Measurement Item Selection Screen ............ 7-18
7.6 Operation Procedure ................................................ 7-24
7.6.1 Selecting Output Destination of Measured
Results .......................................................... 7-24
7.6.2 Selecting Data File Output Directory ............. 7-25
7.6.3 Registering Power Sensor and Setting
Calibration Factor .......................................... 7-26
7.6.4 Setting Reference and 100 MHz Calibration
Factor ............................................................ 7-28
7.6.5 Inputting Programmable Attenuator
Calibration Factor .......................................... 7-29
7.6.6 Inputting Attenuator Calibration Factor for
CDMA Measurement ..................................... 7-30
7.6.7 Starting Measurement ................................... 7-31
7.6.8 Confirmation Items Before Measurement
Start ............................................................... 7-32
7.6.9 Quitting Program ........................................... 7-36