Section 6 Correction Software
6-30
6.6.11 Registering the Power Sensor Serial Number
When “Data_Select” in section [1] is selected on the “Power Sensor Cal Factor Input
Screen,” shown in Fig. 6-22, this causes the “Power Sensor Serial Number Registration
Screen,” shown in Fig. 6-26, to appear. Selecting a data file of a power sensor already
registered or entering a new registration is enabled on this screen. The following sec-
tion shows the names of control functions on this screen as well as an outline of these
functions.
[1] Directory display section This section displays a list of contents of the disk drive selected in section [7].
[2] Directory (File path display section)
This section displays the path leading to the data file selected in section [4] or the data
file set by entering the data file name in section [8].
[3] File Type (File extension display section)
This section displays the extension of data files to be displayed in section [4]. Inciden-
tally, the extension, “.amo,” signifies the amorphous power sensor (MA4601A), while
the extension, “.dio,” signifies the diode power sensor (MA4602A).
[4] Section to display a list of files
This section displays a list of file names with the extension shown in section [3] located
in the directory selected in section [1].
[5] OK (O) (“OK” button) This button is used when a file name has been entered in section [8] or when a file has
been selected in section [4].
[6] Quit (Q) (“Quit” button) This button is used to return to the “Power Sensor Cal Factor Input Screen,” shown in
Fig. 6-22, without selecting a file.
[7] Drive (Disk drive display section)
This section is used to select a disk drive to store a new data file to be registered or
select a disk drive that stores an already registered data file to be selected.
[8] File Name (File name input section)
This section is used to enter a new registration. Entering a data file name already
registered is also enabled.
To Next Page
Loading...
