Section 6 Correction Software
6-24
Select a file to check its data by following the instructions below.
(1) Select “File” –– “Select” in section [1] on the “Measured result Confirmation
Screen” shown in Fig. 6-18. This causes the “Data File Selection Screen,” shown
in Fig. 6-20, to appear.
(2) Select a disk drive that stores a relevant data file from the “Drive” box in section
[2]. This causes section [1] to display a list of directories.
(3) Select a directory that stores a relevant data file from section [1]. This causes a
list of files with the extension shown in section [4] to appear in section [3].
(4) Select a file type in section [4]. Select “.TXT” to refer to the data before correc-
tion and select “.DAT” to refer to the measured results of frequency response
after writing the correction values. This causes file names with the selected ex-
tension to be displayed in section [3].
(5) Select the name of the file you wish to refer to on the list of file names in section
[3], and click the “OK” button in section [5]. This causes the measured results to
be displayed by graph on the “Measured result Confirmation Screen” shown in
Fig. 6-18. Double-clicking on the file name in section [3] also causes the same
processing to be performed.
(6) Select the “Quit” button in section [6] to quit this screen without selecting a file.
This causes the screen to return to the “Measured result Confirmation Screen”
shown in Fig. 6-18.
To Next Page
