7-5
7.5 Outline of Displayed Screen
[4] Address Number (Address number display and selection field)
Highlights only the equipment to be used for the selected measurement items and en-
ables the change of settings. Make the entries by directly typing in the data or by using
the scroll bar located at the right margin of the display field.
The possible input range is between 1 and 30.
[5] Data Output Device (Measured results output destination display field)
Displays the output destination of currently selected measured results. If any settings
are to be changed, make the changes in item [3] “Ouput_Select”.
[6] Measurement Items (Hex) (Measurement item display field)
When a measurement item is selected, displays the bits of the selected item as a hexa-
decimal number.
[7] “Measurement” button Checks the set items and starts the measurement. See paragraph 7.6.8 “Confirmation
Items Before Measurement Start” for more information on items to be confirmed at the
time of starting the measurement.
[8] Serial Number (DUT serial number display and input field)
Input the serial number of the equipment under test. A maximum of eight alphanu-
meric characters can be inputted. A file name is specified when output to a disk is
selected.
[9] Address Number (DUT address number display and selection field)
Displays the Address No. of the currently set device under test. If any settings are to be
changed, make the changes by directly typing in the data or by using the scroll bar
located at the right margin of the display field as explained in item [4].
The allowed input range is between 1 and 30.
[10] “Quit” button Used for exit from this program. See paragraph 7.6.9 “Procedure for Exit from Pro-
gram” for more information on how to quit the program.
To Next Page
Loading...
