MENU > Recording 105
Interval recording parameters
Interval length
The duration the camera waits between every burst of images it captures. Set in
hours:minutes:seconds. Maximum interval length is 2:00:00.
Burst length
The number of frames that are captured by the camera for each burst. Maximum
number of frames is 2000.
Duration mode
Manual: The recording is started and stopped with the REC button.
Preset: The recording is started with the REC button and runs for the set recording
duration. Additionally, it can be stopped with the REC button before the set recording
duration has passed.
Recording duration
The duration of the interval recording in real-time after start. Set in
hours:minutes:seconds. Maximum recording duration is 23:59:59.
Note: When changing the recording duration, the resulting clip length is automatically
updated by the camera.
Note: Only available in duration mode: Preset.
Resulting clip length
The duration of the resulting clip. Set in hours:minutes:seconds.
Note: When changing the resulting clip length, the recording duration is automatically
updated by the camera.
Note: Only available in duration mode: Preset.
15.5 Rec beeper / tally
MENU > Recording > Rec beeper/tally
Start beeper: Acoustic indication for start of recording.
Stop beeper: Acoustic indication for stop of recording.
Card full beeper: Acoustic indication for stop of recording due to full card. Has a
different sound pattern than Start/stop beeper for better distinction.
Tally front: Sets the tally light on the viewfinder front end.
Note: On recording, the tally light turns red.