54 Overlay menu
1 Connect the monitor to an SDI out of the camera. Make sure the SDI
processing of the output is activated.
2 Connect the bus interface cable to the EXT port of the camera.
3 Activate the overlay menu by pressing the "ARRI" touch icon on the monitor.
4 Select a parameter with arrow icons of the monitor.
5 Start editing the parameter by pressing checkmark icon.
6 Select the new parameter value with the arrow icons.
7 Confirm the new value by pressing the checkmark icon.
8 If required, repeat steps 4-7 for other parameters.
9 Exit the overlay menu by pressing the exit icon.
MVF-1
When the overlay menu is activated, the jogwheel of the MVF-1 can be used to select,
edit and confirm parameter changes.
To Next Page
Loading...
