16-6
PPC Manual Revision 1
Chapter 16: Software Functional Overview
Maintenance Port Communication (Do not supply power to the controller)
Connect the cable between the PC’ s USB terminal and the connection port on top of
the controller.
Note
When connecting the PC to a controller using the maintenance port, do not supply power to
the controller, otherwise the controller will not function properly. If the cable is connected to
the controller and the power is turned on or if the controller’ s power supply is turned on and
the cable is connected, disconnect the cable and turn the controller’ s power supply back on
again. This returns the controller to the normal condition.
Remove the attached label.
A spare label is included in the unit
labels supplied with the controller.
Confirm the shape of the connector
and then insert it.
Cable
Parameter Setting Software
To USB terminal
Maintenance Port
The following table shows the functions available between the controller and
Parameter Setting Software when the PC is connected using the controller’ s
maintenance port.
Software Menu Software Function
Communication
Upload all
Download all
Upload parameter data
Download parameter data
Compare communication
Controller operation
Factory defaults
User defaults
Set User defaults
To Next Page
Loading...
