Avaya IPBS2 - Software; Connectors; Leds

Description
Avaya 374x DECT Telephones - User Guide 02/2016
11
Software
The software in the IPBS1 can be updated by downloading new software without disconnecting
the equipment. The new software is stored in flash memory. See System Downgrade for IPBS2
and DB1 on page 132 for information.
Connectors
l Two 8-pin RJ45 modular jacks for LAN/PoE and powering
l A 6-pin RJ12 modular jack for factory testing
LEDs
Note: All amber statuses are warnings that Air synchronization, although still adequate, is fading and
might be lost. A flashing red indicates lost Air synchronization.
Status of LED1 (lower LED) Description
Steady Green Operational
Flashing fast amber Download of firmware in progress.
Steady Amber TFTP mode
Alternating red/green No Ethernet connection
Status of LED2 (upper LED) Description
Not lit IPBS1 operational and no traffic on the IPBS1.
Air synchronization OK.
Steady green IPBS1 operational and traffic on the IPBS1. Air
synchronization OK.
Slow flashing green Fully occupied with traffic. Air synchronization
OK.
Flashing amber Air synchronization inadequate and no traffic.
Slow flashing amber Air synchronization inadequate and fully
occupied with traffic.
Steady amber Air synchronization inadequate and traffic.
Flashing red No air synchronization - searching for air sync
candidates.
Quick flashing red Download of RFP software in progress.