Avaya IPBS2 - Configure Deployment

Configuration
Avaya 374x DECT Telephones - User Guide 02/2016
67
16. Select Update > Config and browse to the previously saved configuration. Click "OK".
17. Reset in order to make the configuration changes take effect, see Reset
on page 141.
18. Repeat step 1 to 3 for all Slaves.
Configure Deployment
This section describes how to configure an IPBS for deployment used for coverage test of air
sync and speech.
NOTE: For coverage test of air sync, two IPBSs must be configured, one as Sync Master and
one as Sync Slave.
Each configuration step is briefly described in the step list below. For more detailed information
see the corresponding subsection in Operation
on page 71.
1. Determine the IP address and access the GUI, see Access the GUI
on page 53.
2. Change the default password, see Change the Default Password
on page 56.
3. Set a static IP address and set DHCP to off, see Set a Static IP Address
on page 92.
4. Set the mode to Master, see Select Mode
on page 103.
5. Perform a reset to restart the IPBS/IPBL in Master mode, see Reset
on page 141.
6. Select system name and password, see Change System Name and Password
on
page 99.
7. Set subscription method, see Set Subscription Method
on page 99.
8. Configure authentication code, see Configure Authentication Code
on page 100.
9. Set default language, see Set Default Language
on page 100.
10. Set frequency band, see Set Frequency Band
on page 100.
11. Enable carriers, see Enable Carriers
on page 101.
12. Set Master Id, see Configure Gatekeeper
on page 104.
13. Assign PARI, see PARI
on page 108. Note: If two IPBss are configured for coverage test
of air sync, both IPBS must have the same system ID.
14. Enter SARI, see SARI
on page 108.
15. Reset in order to make the configuration changes take effect, see Reset
on page 141.
16. For coverage test of speech sync, register one handset in the IPBS configured as Sync
Master, see Add Users
on page 68.
17. Set the mode to Deployment, see Select Mode
on page 103.