54 Avaya 374x DECT Telephones - User Guide 02/2016
It is also accessed by entering http://xxx.xxx.xxx.xxx. In this address, xxx.xxx.xxx.xxx should be
replaced with the IP address determined in Determine the IP Address
on page 54.
Access the GUI and change the default password as described in Change the Default
Password on page 56.
Note: If the GUI cannot be accessed with Internet Explorer 8 or newer, check that the TLS 1.0 option is
activated in the web browser under menu Tools > Internet Option > Advanced > Use TLS 1.0.
Determine the IP Address
The factory setting of the DHCP mode for the LAN1 port is "automatic", at first power up it will
act as a DHCP client. If the network has a DHCP server, it will assign an IP address to the IPBS/
IPBL. If there is no DHCP server in the network, the IPBS/IPBL can be assigned a predefined IP
address. The factory setting of the DHCP mode is to the fixed IP address 192.168.0.1, see 8.2.1
Set Set DHCP Mode
on page 91.
Note: After the first startup the DHCP mode should be changed from "automatic" to either "client" or
"off", see Set DHCP Mode
on page 91.
This section describes how to determine the dynamically allocated IP address. The address is
used to access the IPBS/IPBL using a web browser. Two methods are described:
l In a Network without a DHCP Server on page 54.
l In a Network with a DHCP Server on page 55.
In a Network without a DHCP Server
If the network does not have a DHCP server, and the DHCP mode is set to "automatic" (factory
default), follow the steps below.
Note: If the IPBS/IPBL has been used before, it must be restored to factory default settings by
performing a long hardware reset, see Reset Using the Reset Button
on page 142.
1. Connect an Ethernet cable between the IPBS/IPBL and the computer.
Note: For IPBS, a power adapter must be used.
For IPBL, make sure to use the LAN1 port.
2. Ensure that the computer has an IP address within the same IP address range as the
IPBS/IPBL (192.168.0.1).
3. Perform a hardware reset by shortly pressing the reset button.
The IPBS/IPBL will be assigned the IP address 192.168.0.1 and the netmask
255.255.255.0.
4. Enter http://192.168.0.1 in the browser to access the IPBS/IPBL GUI.
To Next Page
Loading...
