Configuration
Avaya 374x DECT Telephones - User Guide 02/2016
65
18. Configure air synchronization, see Configure Air Synchronization on page 109.
19. Enter the Time Server address, see Trust List
on page 84.
20. Reset in order to make the configuration changes take effect, see Reset
on page 141.
Configure the Standby Master
It is recommended to have a Standby Master in the IP-DECT system. This section describes
how to configure a Standby Master. Each configuration step is briefly described in the step list
below, for more detailed information see the corresponding subsection in Operation
on
page 71.
1. Determine the address and access the GUI, see Access the GUI
on page 53.
2. Change the default password, see Change the Default Password
on page 56.
3. Configure LDAP replicator, enter the IP address, user name and password to the LDAP
server. Alternative LDAP server must not be entered. Select the Enable check box, see
Configure LDAP Replicator
on page 97.
4. Set a static IP address and set DHCP to off, see Set a Static IP Address
on page 92.
5. Enter system name and password, this should be the same system name and password
as in the Master. See Change User Name and Password
on page 72.
6. Enter Primary Master IP Address.
7. Set the mode to Standby Master, see Select Mode
on page 103.
8. Configure the Master settings, see Configure Gatekeeper
on page 104.
9. Enter Master IP address, see PARI
on page 108.
10. Select supplementary services, see PARI
on page 108.
11. Assign PARI, see PARI
on page 108.
12. Configure air synchronization, see Configure Air Synchronization
on page 109.
13. Enter WSM IP address, see Configure Messaging
on page 111.
14. Enter the Time Server address, see Trust List
on page 84.
15. Configure LDAP replicator, enter the IP address, user name and password to the LDAP
server. Alternative LDAP server must not be entered. Check the Enable check box, see
Configure LDAP Replicator
on page 97.
16. Reset in order to make the configuration changes take effect, see Reset
on page 141.
If problem to access the Standby Master from a certain PC after the reset;
l Open a command window in windows by selecting Start > Run and enter "cmd" in the
Open: text field.
To Next Page
Loading...
