Operation
Avaya 374x DECT Telephones - User Guide 02/2016
141
Note: Executing an RFP scan will terminate all calls on the IPBS.
1. Select Diagostics > RFP Scan
2. Click "Start Scanning"
Service Report
To download a service report do the following:
1. Select Diagnostics > Service Report.
2. Click "download".
3. Click “Save” and browse where to save the service report.
Reset
Some configuration changes requires a reset in order to take effect. A reset reboots the
software. There are two ways to perform a reset:
l Idle reset - waits until there are no active calls in the IPBS/IPBL.
l Immediate reset - clears all calls and resets the IPBS/IPBL.
Idle Reset
1. Select Reset > Idle Reset.
2. Click "OK".
3. The IPBS/IPBL will reset when there are no active calls.
Immediate Reset
1. Select Reset > Reset.
2. Click "OK".
3. The IPBS/IPBL will terminate all active calls and reset.
TFTP Mode
Note: When the IPBS/IPBL is in TFTP mode it can only be reached using the gwload utility. This
mode should not be used during normal operation.
To Next Page
Loading...
