Avaya IPBS2 - Change System Name and Password

Operation
Avaya 374x DECT Telephones - User Guide 02/2016
99
l Enable/Disable Early Encryption
l Configure Coder
l Configure Supplementary Services
l Select Master Mode
l Configure Trunks
l Enable/Disable Radio
l Multiple Radio Configuration
l Assign PARI
l Enter SARI
l Configure Air Synchronization
Change System Name and Password
Note: This is only applicable for a Master, never on a Slave. The system name and password must be
the same for all IPBS/IPBLs throughout the system. Reset in order to make the changes take effect, see
Reset
on page 141.
1. Select DECT > System.
2. Note: To access the System tab, the Master mode has to be activated, see Select
Mode on page 103.
3. Write a system name in the System Name text field.
4. Enter a new password in the Password text field. Repeat the password.
5. Click "OK".
Note: It is recommended to create a backup of the IPBS configuration when the password has been
changed, see Backup
on page 132.
Set Subscription Method
The IP-DECT system can be set to use the following subscription methods:
l With User AC - Individual Registration and Auto Registration is possible.
l With System AC - Anonymous Registration and Individual Registration is possible.
l Disable - Registration is not possible.
Select subscription method:
1. Select DECT > System.