140 Avaya 374x DECT Telephones - User Guide 02/2016
Ping
The ping function is used to determine the response time from the IPBS/IPBL to a certain IP
address. It can be used to analyse the connection between the IP-DECT system components.
1. Select Diagnostics > Ping.
2. Enter an IP address in the IP Address text field.
3. Press "Enter" on the keyboard.
Traceroute
The traceroute function displays how packets travel from the IPBS/IPBL to a certain IP address.
The result is an ordered list of IP addresses with the measured round trip time.
1. Select Diagnostics > Traceroute.
2. Enter an IP address in the IP Address text field.
3. Press "Enter" on the keyboard.
Environment
This section only applies to the IPBL.
The environment tab gives information power supply and consumption. It also display
temperature and fan status.
1. Select Diagnostics > Environment.
2. The following information is available in the Power section:
l Power supply - AC or DC power port.
l Voltage - input voltage.
l Current consumption - total consumption for the IPBL an the connected RFPs.
– Max 4,0 A when supplied with AC power port
– Max 5,2 A when supplied with DC power port
Figure 24.
3. The following information is available in the Environment section:
l Temperature - °C
l Fan status - OK, not OK
RFP Scan
This section only applies to the IPBS.
To scan for occupied system IDs of other IP-DECT systems within the coverage area, perform
an RFP scan following the steps below.
To Next Page
Loading...
