66 Avaya 374x DECT Telephones - User Guide 02/2016
l Enter the following commands
arp -d(Delete the arp cache)
nbtstat -R(Empty the nbtstat cache)
l Restart the web browser.
Configure the Slave/Radio
This section describes how to configure the Slave. Each configuration step is briefly described
in the step list below, for more detailed information see the corresponding subsection in
Operation
on page 71.
Note: When one Slave is configured, the configuration can be saved and uploaded to the other Slaves
in the system.
1. Determine the address and access the GUI, see Access the GUI on page 53.
2. Change the default password, see Change the Default Password
on page 56.
3. Set DHCP mode to "Client", see Dynamic IP address using DHCP
on page 93.
4. Enable the Radio in the IPBS/IPBL, see Enable the Radio
on page 107.
5. If the radio acts as a Standby Master, perform the following:
6. Configure LDAP replicator, enter the IP address, user name and password to the LDAP
server and the alternative LDAP server. Check the Enable check box, see Configure
LDAP Replicator on page 97.
7. Enter the system name and password, this must be the same system name and password
as in the Master, see Change System Name and Password
on page 99.
8. With LDAP replication enabled, the password will be verified against the Master. If the
password is wrong a single dot (.) will appear in the text field.
9. Set the mode to Slave, see Select Mode
on page 103.
10. Enter Master and Standby Master IP addresses, see 7.5.14 Enter IP Address to the Pari
Master on page 63. PARI
on page 108
11. Configure air synchronization, see Configure Air Synchronization
on page 109.
12. Enter the Time Server address, see Trust List
on page 84.
13. Reset in order to make the configuration changes take effect, see Reset
on page 141.
14. Save the configuration of the Slave, see Backup
on page 132.
Configure the rest of the IPBS/IPBL following the steps below:
Note: Uploading the same configuration to all slaves can only be done if the DHCP is set to client.
15. Determine the address.
To Next Page
Loading...
