Avaya IPBS2 - Configure the Master

64 Avaya 374x DECT Telephones - User Guide 02/2016
Configure the Master
This section describes how to configure the Master. Each configuration step is briefly described
in the step list below. For more detailed information see the corresponding subsection in
Operation
on page 71.
1. Determine the address and access the GUI, see Access the GUI
on page 53.
2. Change the default password, see Change the Default Password
on page 56.
Note: This step is not needed if the Master is configured as Mirror. In that case, jump to the next step.
Configure LDAP user name and password, select the Write Access check box, see Configure LDAP
Server on page 96.
3. Set a static IP address and set DHCP to off, see Set a Static IP Address on page 92.
4. Set the mode to Active or Mirror, see Select Mode
on page 103.
5. Perform a reset to restart the IPBS/IPBL in Master mode, see Reset
on page 141.
6. Select DECT > System and enter password.
7. Select system name and password, see Change System Name and Password
on
page 99.
8. Set default language, see Set Default Language
on page 100.
9. Select supplementary services, see PARI
on page 108.
10. Set frequency band, see Set Frequency Band
on page 100.
11. Configure the Master settings, see Configure Gatekeeper
on page 104.
12. Set the Master IP address to 127.0.0.1, see PARI
on page 108.
13. Perform a reset to restart the IPBS/IPBL in Master mode, see Reset
on page 141.
If problem to access the Master from a certain PC after the reset;
l Open a command window in windows by selecting Start > Run and enter "cmd" in the
Open: text field.
l Enter the following commands
l Restart the web browser.
14. Select supplementary services, see PARI
on page 108.
15. Assign PARI, see PARI
on page 108.
16. Enter SARI, see SARI
on page 108.
17. Enter AIWS2 IP address, see Configure Messaging
on page 111
arp -d (Delete the arp cache)
nbtstat -R (Empty the nbtstat cache)