146 Avaya 374x DECT Telephones - User Guide 02/2016
Standby master active (Master) 0x00030201 IPBS/
IPBL
X
User registration failure (Master) 0x00030202 IPBS/
IPBL
X
Connection to Radio lost (Master) 0x00030204 IPBS/
IPBL
X
Primary/redundant trunk is down (Master) 0x00030205 IPBS/
IPBL
X
Master active (Master)
This event is generated when the Mirror becomes
active.
0x00030206 IPBS/
IPBL
X
Master inactive (Master)
This event is generated when the Mirror becomes
inactive.
0x00030207 IPBS/
IPBL
X
Limit of static radios is reached (Master)
This is an alarm which is generated when the
number of radios in the radios list (Device
Overview > Radios) is reaching 2100. The alarm is
cleared once the number of radios goes below 2100.
0x00030208 IPBS/
IPBL
X
No Media data received (RTP)
No RTP packets from remote side were received on
a connected call. This points to either a NAT
problem (private RTP address was given to remote
side) or a general signaling problem (media
negotiation).
0x00050001 IPBS/
IPBL
X
Excessive loss of data (RTP)
This event is generated if in a period of 10s more
than 3% received RTP packets were lost. This is an
indication of a network problem and it is
recommended to check the involved media IP
addresses and what kind of device that is involved.
0x00050002 IPBS/
IPBL
X
Wrong payload type received (RTP)
Caused by signaling/negotiation problems
(interoperability). An endpoint sends RTP packets
with a payload type other than negotiated. Wrong
Payload Type is a message if there is a Media
Problem with a another PBX.
0x00050003 IPBS/
IPBL
X
Stun failed (RTP) 0x00050004 IPBS/
IPBL
X
Unexpected message (H323)
A message was received, which was not expected
by the protocol in this state. This could be caused
by network problems or by incompatible
equipment.
0x00060001 IPBS/
IPBL
X
Status inquiry (H323) 0x00060002 IPBS/
IPBL
X
To Next Page
Loading...
