Name Description
UDP Port for discovery and
test messages
Specifies the port used to receive packets from an SLA Monitor server.
Valid value is an integer from 6000 to 65535. The default value is
50011.
Other
Serial Port Specifies if the port for network traffic is enabled or disabled.
The options are:
• Enable
• Disable (default)
Configuring certificates
About this task
When you click on any configuration field, the screen displays the details of that field in the
Parameter Help section.
Procedure
1. Log in to the web interface as an administrator.
2. In the navigation pane, click Certificates.
3. Configure the following areas:
• Certificates
• Online Certificates Status Protocol (OCSP)
• SCEP
• PKCS12
• Web Server
4. Click one of the following:
• Save: To save the configuration changes.
• Reset to Default: To revert to the default values.
Certificates field descriptions
Name
Description
Certificates
Available Trusted Certificate Displays the file names of available certificates for authentication.
Table continues…
Phone configuration
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 160
Comments on this document? infodev@avaya.com
To Next Page
Loading...
