Avaya J100 Series - Enabling Access to Web Interface of the Phone

From the phone web interface, you can view the status of the configurations, configure the
parameters, and reset the values to default. The following are the tabs on the web interface of
Avaya J100 Series IP Phones:
• Status
• Network
• Ethernet
• Wi-Fi
• SIP
• Settings
• Date & Time
• Management
• Password
• Debugging
• Certificates
• Environment Settings
• Background and Screen Saver
• Calendar
• Multicast Paging
• Key Configuration
• Softkey Configuration
• Shared Lines Configuration
• Restart
• Reset to Default
Note:
On configuring some of the parameters, you are required to reboot the phone after you log out
of the web interface. These parameters are marked with an asterisk (*).
On configuring some of the parameters, you are required to reboot the phone immediately.
These parameters are marked with two asterisks (**).
Enabling access to web interface of the phone
Administrators can enable access to the web interface of the phone through one of the following
methods:
• By using the phone Administration menu.
Configuring the phone using the web interface
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 95
Comments on this document? infodev@avaya.com