SET SYSLOG_LEVEL 1
SET SYSLOG_ENABLED 0
SET LOGSRVR ""
SET LOG_CATEGORY ""
Enable the Phone Lock feature
To enable the Phone Lock feature, you need to provide SIP login and password information to the
user.
You can configure the Phone Lock feature so that users can manually lock their phones using the
Lock soft key on the Idle phone screen or the Lock feature key. You can also set the idle time
interval after which the phone automatically locks.
To do this, set the following 46xxsettings.txt parameters:
•
SET ENABLE_PHONE_LOCK 1
• SET PHONE_LOCK_IDLETIME: use any value other than 0 for this parameter to set the idle
time interval.
Additional settings
The following settings are turned off by default, but if you want to ensure that data privacy is
maintained as required, make sure you observe the following settings:
•
SET SNMPADD ” “
•
SET TPSLIST ” “
•
SET SLMSTAT ” “
Use HTTPS values for the following settings:
•
USER_STORE_URI
•
XSI_URL
• CONFIG_SERVER_SECURE_MODE — do not set to 0
Use TLS values for the following settings:
•
SIP_CONTROLLER_LIST
•
SIP_CONTROLLER_LIST_2
• SET SIPSIGNAL 2 — TLS is used by default
• SET ENABLE_OOD_MSG_TLS_ONLY 1 — TLS is used by default
Geographical restrictions on encryption
Starting from R.4.0.4., SRTP is not supported on Avaya J100 Series IP Phones sold in Russia,
Belarus, Kazakhstan, Kyrgyzstan, and Armenia to meet local restrictions on the use of encryption.
Data Privacy Controls Addendum
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 274
Comments on this document? infodev@avaya.com
To Next Page
Loading...
